Kramer Electronics RC-63DL - Manual (Page 19)

Using Your Room Controller
15
15
5.1 Operating the Room Controller
In the following example 1 Figure 10 that is illustrated in , the room controller is
labeled with specific functions and each button is programmed 2 to perform
several tasks 3 Table 11 as defined in .
Table 11: The Commands Configuration
The Label The Macro Sequence
ROOM
Figure 10: RC-63DL Labels Setup
ON • Power up the projector
• Power up the DVD player
• Roll down the projector screen
• 1 minute delay [for the projector to heat
up]
• The projector selects the DVD input
OFF • Power down the projector
• Stop the DVD player
• Power down the DVD player
• Stop the VCR
• Power down the VCR
• Roll up the projector screen
DVD • Stop the video player
• The projector selects the DVD input
• Play the DVD
VCR • Stop the DVD
• The projector selects the VCR input
• Play the VCR
VOLUME • Use the VOLUME knob to adjust the
audio level
5.2 Using the Macro Buttons
Pressing any button initiates a macro sequence 4 , during which the button blinks
(as programmed by the system integrator).
1 This is only one example among numerous possibilities, each button can be configured as required. In this example, two
buttons are not assigned
2 By the technical installer
3 A macro sequence, including several commands per button, carried out one after the other
4 The macro sequence can be carried out instantly or can take a while, depending on the delay times included in the sequence