Your vs-88hcb – Kramer Electronics VS-88HCB User Manual
Page 10
Your VS-88HCB
7
Table 2: VS-88HCB 8x8 Component / Video / Audio Matrix Switcher Rear Panel Features
#
Feature
Function
14
AUDIO INPUTS
Terminal
Block Connectors
Connect to the balanced stereo audio sources (from 1 to 8)
15
AUDIO OUTPUTS
Terminal
Block Connectors
Connect to the balanced stereo audio acceptors (from 1 to 8)
16 Ethernet Connector
Connects to the PC or other Serial Controller through computer networking
17
RS-485
Port
Pin G is for the Ground connection
1
; pins B (-) and A (+) are for RS-485
18
REMOTE IR
3.5mm Mini
Jack
Connect to an external IR receiver unit for controlling the machine via an IR
remote controller (instead of using the front panel IR receiver)
2
19 Power Connector with Fuse
AC connector, enabling power supply to the unit
20
Factory Reset
Button
Press to reset to factory default definitions
3
:
IP number 192.168.1.39
Mask – 255.255.255.0
Gateway – 192.168.1.1
21 Dipswitches
Dipswitches for setup of the unit (1, 2 and 3 are for setting the machine
number; 4 is for RS-485 bus termination; 5 is for Reply; 8 is for RS-485 PC
communication)
22
RS-232
9-pin D-sub Port
Connect to the PC or the remote controller
23
Video/Y
S/PDIF/
C
Connect to the composite video (Video/Y) and digital audio (S/PDIF/C)
acceptors, or to the s-Video (Video/Y and S/PDIF/C) acceptors
C
R
/P
R
C
B
/P
B
OUT
BNC
Connectors
(from 1 to 8)
Y
Connect to the component video (Y, C
B
/P
B
, C
R
/P
R
) acceptors
24
Video/Y
S/PDIF/C
Connect to the composite video (Video/Y) and digital audio (S/PDIF/C)
sources or to the s-Video (Video/Y and S/PDIF/C) sources
C
R
/P
R
C
B
/P
B
INPUT
BNC
Connectors
(from 1 to 8)
Y
Connect to the component video (Y, C
B
/P
B
, C
R
/P
R
) sources
1 The ground connection is sometimes connected to the shield of the RS-485 cable. In most applications, the ground is not
connected
2 Can be used instead of the front panel (built-in) IR receiver to remotely control the machine
3 Turn the machine OFF, then turn the machine ON while pressing the FACTORY RESET button. The unit powers up and
loads its memory with the factory default definitions