3 configuring the ethernet port, 6 controlling via the c.c remote connector, Configuring the ethernet port – Kramer Electronics VS-41HD User Manual
Page 16: Controlling via the c.c remote connector, Figure 8: using the c.c remote connector
Connecting Your VS-41HD 4x1 HD/SD-SDI Switcher / DA
13
13
6.5.2
Connecting the ETHERNET Port via a Network Hub (Straight-
Through Cable)
You can connect the Ethernet port of the VS-41HD to the Ethernet port on a
network hub or network router, via a straight-through cable with RJ-45
connectors.
6.5.3
Configuring the Ethernet Port
After connecting the Ethernet port, you have to install and configure it.
For detailed instructions on how to install and configure your Ethernet port,
see the “Ethernet Configuration (FC-11) guide.pdf” on our Web site:
6.6 Controlling via the C.C REMOTE Connector
Connecting the C.C REMOTE terminal block connector to a contact closure
switch lets you route an input to the output by remote control. For example, to
route input 1 to the output, as the example in
touch input # 1 to the Ground (G).
Figure 8: Using the C.C REMOTE Connector