Kramer Electronics VS-41HD - Manual (Page 10)

Connecting Your VS-41HD 4x1 HD/SD-SDI Switcher / DA
7
7
6 Connecting Your VS-41HD 4x1 HD/SD-SDI Switcher / DA
You can use your VS-41HD to switch one of the four standard definition / high
definition SDI inputs to the two identical high definition / standard definition
SDI outputs, as the illustration in
Figure 2 shows.
To connect the VS-41HD 4x1 HD/SD-SDI Switcher / DA, as shown in the
example in
Figure 2 , do the following
1
1. Connect up to four SDI sources to the INPUTS BNC connectors:
:
 An HD/SD SDI camera to INPUT 1
 An HD SDI camera to INPUT 2
 An HD SDI camera to INPUT 3
 An SDI VTR to INPUT 4
2. Connect the SDI OUTPUT BNC connectors to up to
2
3. Set the dipswitches (see section
two SDI acceptors (for
example, two HD/SD SDI displays).
6.1 ).
4. As an option
3
 A Genlock source to the GENLOCK BNC connector
, connect:
 The LOOP BNC connector to the GENLOCK
connector of the next unit in the line, and release the
TERM button for looping
4
5. Connect a PC and/or controller (if required), to the:
 RS-232 port (see section
6.2 ), and/or
 RS-485 port (see section
6.3 ), and/or
 ETHERNET connector (see section
6.4 )
6. If required
3
, connect a remote contact closure switch (see section 6.6 )
7. Connect the power cord
5
1 Switch OFF the power on each device before connecting it to your VS-41HD. After connecting your VS-41HD, switch on
its power and then switch on the power on each device
.
2 When only one output is required, connect that output, and leave the other output unconnected
3 Not illustrated in Figure 2
4 Pushed in terminates the input. Release when the input extends to another unit
5 We recommend that you use only the power cord that is supplied with this machine