Kramer Electronics VS-21HDCP-IR - Manual (Page 12)

VS-21HDCP-IR - Acquiring an EDID 9
5 Acquiring an EDID
Initially, the VS-21HDCP-IR operates with the factory default EDID. This lets you
connect the power before connecting one of the acceptors or the source. You can
acquire the EDID from the output to one of the two inputs, or set the acquired
EDID and the default EDID to both inputs.
To acquire the EDID, do the following:
1. Connect the power.
2. Connect the output.
3. Press and hold the SELECT button.
The IN LEDs illuminate in the following cycle: IN 1 flashes, IN 2 flashes, both
illuminate and both blink (default).
4. Release the SELECT button when reaching the desired set up.
The EDID is now acquired:
IN LED Status The EDID Acquired when
Releasing the SELECT Button
IN 1 flashes Output to input 1
IN 2 flashes Output to input 2
IN 1 and IN 2 illuminate Output to Input 1 and input 2 simultaneously
IN 1 IN 2 flash Default value to Input 1 and input 2 simultaneously