Kramer Electronics VS-21HDCP-IR - Manual (Page 11)

8 VS-21HDCP-IR - Connecting the VS-21HDCP-IR
4.2 Controlling via the Remote Control Transmitter
You can use the remote control transmitter to switch INPUT 1 or 2 to the output.
Before doing so, set it to work with the VS-21HDCP-IR by assigning a GROUP
number.
The setup parameters for the remote control transmitter are as follows: router number = 1
(default); group number = 11, single digit mode (default), video (default). For further details,
see the RC-IR3 user manual.
To assign the GROUP number on the remote control transmitter, do the following:
1. Point the remote control transmitter at the remote receiver and press the
GROUP key.
2. Press key 11.
This sets and saves the group number.
To switch INPUT 1 or 2 to the output via the remote control transmitter, press key
1 or 2.
4.3 Controlling via the Remote Terminal Block Connector
The contact closure remote control pins operate in a similar way to the input
SELECT button. Using the contact closure remote control lets you select an input
by remote control. To do so, temporarily connect the required input (IN1 or IN2)
pin on the REMOTE terminal block connector to the G (ground) pin, as illustrated
in the examples in Figure 3 .
Warning: DO NOT connect more than one PIN to the G PIN at the
same time.
To select IN1, attach PIN IN1 to the G PIN: To select IN2, attach PIN IN2 to the G PIN
Figure 3: Connecting the REMOTE Input Select Connector
!