Kramer Electronics VP-61xl - Manual (Page 13)

KRAMER ELECTRONICS LTD. 12
11.1 Power and Indicators
Problem Remedy
No Power 1. Confirm that power connections are secured at the
machine and at the receptacle. Make sure the
receptacle is active, outputting the proper voltage.
2. If still there is no power, remove power cord from AC
outlet and then using a flat head screwdriver, remove
the fuse holder located directly below the power
connector on your switcher.
3. Confirm that the fuse is good by looking for the wire
connected between the ends of the fuse. If the wire is
broken, replace the fuse with another, with the same
rating.
11.2 VGA/XGA Signal
Problem Remedy
No signal at the
output device
1. Confirm that your sources and output device are
powered on and connected properly.
2. Confirm that any other device in the signal path have
the proper input and/or output selected.
11.3 Audio Signal (VP-61xl only)
Problem Remedy
No audio at the
output device,
regardless of
input selected
1. Confirm that your sources and output device are
powered on and connected properly.
2. Confirm that any other amplifiers in the signal path
have the proper input and/or output selected. Pay
special attention to input amplifiers that may be built
into your acceptor.
Audio level is too
low
1. Confirm that the connecting cables are of high quality
and properly built.
2. Check level controls located on your source input
device or output display or recorder.