Kramer Electronics VP-411DS - Manual (Page 9)

Connecting the VP-411DS 4x1 Automatic UXGA / Audio Switcher
7
5 Connecting the VP-411DS 4x1 Automatic UXGA / Audio Switcher
.
This section describes how to:
• Connect the VP-411DS (see
Section 5.1 )
• Select the default master source signal (see
Section 5.2 )
• Connect the REMOTE connector (see
Section 5.3 )
• Connect a PC (see
Section 5.4 )
5.1 Connecting the VP-411DS 4x1 Automatic UXGA / Audio Switcher
To connect your VP-411DS
1
Figure 3 , as illustrated in the example in :
1. Connect up to four
2
UXGA/AUDIO sources (for example, computer graphics sources)
to the UXGA IN 15-pin HD connectors and to the AUDIO IN 3.5mm mini connector
3
2. Connect the UXGA OUTPUT 15-pin HD connector and the AUDIO OUTPUT 3.5mm
mini connector to the acceptor
.
3
(for example, a display and speakers).
3. If required, connect a local display to the UXGA IN 1 LOOP 15-pin HD connector.
4. Set the PRIORITY DIP-switches (see Section 5.2 ).
5. If required, connect:
 The contact closure remote control PINS (see
Section 5.3 )
 PC and/or controller to the RS-232 port (see
Section 5.4 )
6. Connect the 12V DC power adapter to the power socket and connect the adapter to the
mains electricity.
1 Switch OFF the power on each device before connecting it to your VP-411DS. After connecting your VP-411DS, switch on its power
and then switch on the power on each device
2 You do not have to connect all the inputs
3 Audio connections are not shown in Figure 3