Kramer Electronics VM-24HDCP - Manual (Page 14)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VM-24HDCP
12
6.3.2 Acquiring the Default EDID
To reset to the default EDID, do the following:
1. Connect the power supply.
2. Press the EDID SELECT button and set it to the Default EDID mode.
All the OUTPUT STATUS LEDs flash simultaneously.
3. Press the EDID READ button to copy the default EDID to the inputs
1
.
While the EDID is being copied, the EDID SELECT and READ buttons
illuminate.
The new EDID is copied when both buttons no longer illuminate.
6.3.3 Acquiring the Auto-mix EDID from the Connected Outputs
The EDID acquired is a weighted average of all the connected outputs. For
example, if several displays with different resolutions are connected to the
outputs, the acquired EDID supports all the resolutions, as well as other
parameters included in the EDID.
To acquire the Auto-mix EDID:
1. Connect the power supply.
2. Connect the desired output display devices.
3. Enter the Auto-mix mode as defined in Table 2 .
The OUTPUT STATUS LEDs flash in sequence.
4. Press the READ button to copy the EDID of the selected OUTPUT to the
inputs
1
.
While the EDID is being copied, the EDID SELECT and READ buttons
illuminate.
The new EDID is copied when both buttons no longer illuminate.