Kramer Electronics VM-24HDCP - Manual (Page 10)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VM-24HDCP
8
6 Connecting the VM-24HDCP
To connect the VM-24HDCP, as illustrated in the example in Figure 2 , do
the following
1
1. Connect
:
2 3
the two DVI sources (for example, a DVD player and a set top
box) to the INPUT 1 and INPUT 2 connectors, respectively.
2. Connect the DVI OUTPUT connectors
3
 OUTPUT 1 connector to acceptor 1 (for example, a plasma
display)
to up to four DVI acceptors, using
Kramer DVI cables. In this example, connect the:
 OUTPUT 2 connector to acceptor 2 (for example, an LCD TV)
 OUTPUT 3 connector to acceptor 3 (for example, an LCD TV)
 OUTPUT 4 connector to acceptor 4 (for example, a plasma
display)
3. If required, connect a PC and/or controller to the RS-232 port (see Section
6.1 ).
4. Connect the power cord to the mains electricity (not shown in Figure 2 ).
5. If required, acquire the EDID (see Section 6.3 ).
1 Switch OFF the power on each device before connecting it to your VM-24HDCP. After connecting your VM-24HDCP,
switch on its power and then switch on the power on each device
2 Using the Kramer HDCP copper cables (C-FODM/FODM)
3 As required. Up to two inputs and four outputs can be connected. Not all inputs and outputs need to be connected