Kramer Electronics VM-114H4C - Manual (Page 10)

Using the VM-114H4C
7
7
Figure 2 and Table 2 define the rear panel VM-114H4C.
Figure 2: VM-114H4C Rear Panel
Table 2: VM-114H4C Rear Panel Features
# Feature Function
11 RS-232 9-pin D-sub (F)
Connector
Connect to a PC or remote controller
12 12V DC Power Connector Connect to the +12V DC power adapter, center pin positive
13 IN1 (HDMI) Input
HDMI Connector
Inputs
Connect to an HDMI source
14 IN2 (CAT5) Input
RJ-45 Connector
Connect to a TP source (for example, PT-571 HDMI Line
Transmitter, VM-114H2C or VM-114H4C)
15 OUT 1
TP RJ-45 Output
Connectors
Connect to the TP acceptors (for example, PT-572+ HDMI Line
Receiver, VM-114H or VM-114H4C)
OUT 2
OUT 3
OUT 4
5 Using the VM-114H4C
This section describes how to connect the VM-114H4C (see Section 5.1 ) and how
to use the EDID SELECT button (see Section 5.2 ).
5.1 Connecting the VM-114H4C
To connect
1
the VM-114H4C as illustrated in the example in Figure 3 :
1. Connect the HDMI source (for example, a DVD player) to the IN 1 (HDMI)
connector.
2. Connect the TP source (for example, a PT-571 HDMI Line Transmitter
2
,
another VM-114H2C or a VM-1114H4C) to the IN 2 (CAT5) connector.
1 Switch off the power on each device before connecting it to your VM-114H4C. After connecting your VM-114H4C, switch on its
power and then switch on the power on each device
2 Another example is the TP-573 Twisted Pair Line Transmitter