Festo Линейные приводы DGO, дюймовые - Manual (Page 27)

DGO−...−A−B
Festo DGO−...−A−B 0410b English
27
6. Open up the one−way flow control valves
slowly again until the desired speed is
reached.
7. Open up the adjusting screws for the end
position cushioning on both sides until
the desired cushioning is reached.
The moveable mass should reach the end
position safely without striking hard
against it.
8 Operation
Warning
Make sure that:
Ĉ nobody can place his/her hand in the
path of the moving mass (e.Ăg. by
providing a protective grill).
Ĉ there are no objects in its path.
It must not be possible to touch the
DGO−... until it has come to a complete
stand.
Warning
Make sure that the moveable mass is always cushioned gently.
Otherwise the magnet coupling will tear off (see Eliminating faults").
With vertical or sloping drive mountings, the moveable mass will then slide
down.
Fig. 20
ÓÓ
Fig. 21
У
У
У
УУ
УУ
Fig. 22