beautypg.com

Festo Линейные приводы DGO, дюймовые User Manual

Page 26

background image

DGO−...−A−B

Festo DGO−...−A−B 0410b English

26

2. Close the adjusting screws for the end

position cushioning on both sides
ć completely,
ć then loosen them one turn.

3. Pressurize the DGO−... as follows:

ć slow pressurization of one side or
ć simultaneous pressurization of both

sides with subsequent exhausting of
one side.

Otherwise excessive loadings will occur at the start when the slide moves into
an end position too quickly or without an air cushion.

For slow start−up pressurization, use start−up valve
type HEL−... / HEM−...Ă.

4. Start a test run.

5. Check whether the following settings need to be modified.

ć the slide speed
ć the end position cushioning.

Mass geometries with projection in the longitudinal direction of the slide:

Warning

Note that the following screws must only
be turned when the DGO−... is at a stand:
Ĉ the adjusting screws for the end

position cushioning

Ĉ the adjusting screws for the one−way

flow control valves.

ÓÓ

Fig. 17

У

У

У

У

У

У

У

У

У

У

У

У

У

Fig. 18

Fig. 19

This manual is related to the following products: