Muxlab CCTV IP PoE Extender 2-Pack - Manual

© MuxLab Inc. 94-000720-B
8495 Dalton Rd, Montreal, Quebec, Canada. H4T 1V5
Tel: (514) 905-0588 Fax: (514) 905-0589
Toll Free (North America): (877) 689-5228
E-mail: [email protected] URL: www.muxlab.com
Specifications
Environment PoE CCTV IP
Devices PoE CCTV IP cameras with a 10/100Mb/s Ethernet port, using up to 14
Watts.
Standard supported Ethernet side:
IEEE 802.3 10BaseT,
IEEE 802.3U 100Base-TX
IEEE 802.3af compatible PoE
Maximum distance vs.
speed between unit 10 Mbps at 7W with good RG59: 1600ft (500m)
10 Mbps at 14W with good RG59: 1000ft(300m)
100 Mbps at 14W: 330ft (100m)
The maximum distance will vary depending on the coax cable.
Cable between unit Coax 75 ohm RG59/RG6 or better. (avoid CCS cable)
Cable for Ethernet port
(Not included) Two CAT 5/5e/6 UTP cables are required (straight), up to 10ft(3m).
Indicator Power present.
Ethernet connector One RJ45S.
Connector to connect
the two units BNC 75 ohms
PoE Mode Switch Manual switch selects between PoE Mode A or Mode B
Mode A: Most PoE switches
Mode B: Most PoE injectors
Power consumption 0.5 Watts, from the PoE. No external supply required.
Temperature Operating: 0° to 60°C Storage: -55° to 85°C
Humidity: Up to 95% non-condensing
Enclosure Plastic
Dimensions 2.40” x 2.25” x 1.00” (6.1 x 5.7 x 2.54 cm)
Weight 0.15 lb. (70 g)
Compliance Regulatory: FCC, CE, RoHS Flammability: 94V0
Warranty 2 years
Ordering information 500111 CCTV IP PoE Extender.
CCTV-IP PoE Extender
500111
Quick Installation Guide
Overview
The CCTV IP PoE Extender (500111) allows one IP camera (7 Watts) to be connected
up to 1600 ft (500 m) via a single 75-ohm coax cable in a point-to-point configuration.
The product works in pairs and the power consumption is low enough so that it does not
load the PoE source or switch. The maximum distance depends on the grade of coax
cable and the power consumption of the camera.
Applications
CCTV IP surveillance
Ethernet inter-connections