General power tool safety warnings, Description of symbols, Specification – Silverline Video Inspection Camera User Manual
Page 7

6
GB
Carefully read and understand this manual and any label
attached to the tool before use. Keep these instructions with the
product for future reference. Ensure all persons who use this
product are fully acquainted with this manual.
Even when used as prescribed it is not possible to eliminate all
residual risk factors. Use with caution. If you are at all unsure
of the correct and safe manner in which to use this tool, do not
attempt to use it.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
Work Area Safety
a)
Keep work area clean and well lit. Cluttered or dark areas
invite accidents
b)
Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Power tools create sparks which may ignite the dust
or fumes
c)
Keep children and bystanders away while operating a
power tool. Distractions can cause you to lose control
Electrical Safety
a)
Power tool plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
earthed (grounded) power tools. Unmodified plugs and
matching outlets will reduce risk of electric shock
b)
Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators. There
is an increased risk of electric shock if your body is earthed
or grounded
c)
Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of electric
shock
d)
Do not abuse the cord. Never use the cord for carrying,
pulling or unplugging the power tool. Keep cord away
from heat, oil, sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric shock
e)
When operating a power tool outdoors, use an extension
cord suitable for outdoor use. Use of a cord suitable for
outdoor use reduces the risk of electric shock
f)
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of electric
shock
NOTE: The term “residual current device (RCD)” may be
replaced by the term “ground fault circuit interrupter (GFCI)”
or “earth leakage circuit breaker (ELCB)”.
Personal Safety
a)
Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use a power
tool while you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention while
operating power tools may result in serious personal injury
Description of Symbols
The rating plate on your tool may show symbols. These represent
important information about the product or instructions on its use
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Conforms to relevant legislation and safety standards
Environmental Protection
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice
Specification
Imaging sensor:................... CMOS
Total pixels: ........................ 640 x 480 (PAL) /
........................................... 640 x 480 (NTSC)
Horizontal viewing angle: .... 36°
Minimum illumination: ......... 0 Lux
Power: ................................ 4 x AA batteries
Waterproof capacity: .......... IP67 (lens/tube only)
LCD screen type: ....................2.7° TFT – LCD
Cable diameter: ................... 9mm
Cable length: ....................... 1m
LCD effective pixels: ............ 960 x 240
Video system: ...................... PAL / NTSC
Capacity of micro SD card: . Supports up to 32G
Picture type: ........................ JPEG
Video type: .......................... .AVI
Picture/video pixels: ............ 640 x 480
Video size: .......................... 27Megabyte per min
Frame rate:.......................... 5-30 frames per second,
........................................... adjustable.
Data transmission: .............. USB 2.0
Dimensions: ....................... 263 (W) x 86 (D) x 49 (H) mm
...................................................(excl. flexible tube)
Weight: ................................ 420g (approx.)
Operating temperature: ...... 10 - 50°C / 14° - 122° F
Operating humidity: ............. 15 - 85%RH
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
913738_Z1MANPRO1.indd 6
27/07/2012 12:22