beautypg.com

Rugged Ridge 6-Piece Body Armor Kit, 97-06 Jeep Wrangler (TJ) User Manual

Page 10

background image


Step 22:
Clean mounting surface with a strong cleaner or rubbing alcohol. Avoid
areas that the product will not be adhered to.
THIS MUST BE DONE FOR ADHESIVE TAPE TO PROPERLY STICK.

FAILURE TO CLEAN COULD RESULT IN POOR ATTACHMENT AND
FAILURE OF PRODUCT TO STAY ATTACHED.

Allow area to dry completely before attaching body armor.


Step 23:
Test fit the Rear Seal Armor to the vehicle before removing the plastic
backing film. This will aid in aligning the piece properly before securing with the
two-sided 3M tape.

Step 24: Position armor onto lower body seal. Make sure that it is evenly spaced
before applying any pressure to armor. When satisfied with placement apply
pressure to all areas to properly secure armor to vehicle. Reinstall lower rubber
tire stopper.

Part Number 11650.10 (Front Frame Cover)

Step 25: Remove the (4) mounting bolts located on the front outer frame of the
vehicle (2 per side). Remove the stock cover and replace with the new Frame
guard. Reinstall with original bolts.