Goulds Pumps 3620 - IOM User Manual
Goulds Pumps Pumps
Table of contents
Document Outline
- Introduction and Safety
- Transportation and Storage
- Product Description
- Installation
- Preinstallation
- Baseplate-mounting procedures
- Install the pump, driver, and coupling
- Pump-to-driver alignment
- Alignment checks
- Permitted indicator values for alignment checks
- Alignment measurement guidelines
- Attach the dial indicators for alignment
- Perform angular alignment for a vertical correction
- Perform angular alignment for a horizontal correction
- Perform parallel alignment for a vertical correction
- Perform parallel alignment for a horizontal correction
- Perform complete alignment for a vertical correction
- Perform complete alignment for a horizontal correction
- Grout the baseplate
- Piping checklists
- Commissioning, Startup, Operation, and Shutdown
- Preparation for startup
- Remove the coupling guard
- Check the rotation - Frame Mounted
- Couple the pump and driver
- Bearing lubrication
- Shaft sealing with a mechanical seal
- Connection of sealing liquid for mechanical seals
- Prime the pump with the suction supply above the pump
- Start the pump
- Pump operation precautions
- Shut down the pump
- Make the final alignment of the pump and driver
- Doweling the pump casing
- Maintenance
- Maintenance schedule
- Bearing maintenance
- Mechanical-seal maintenance
- Disassembly
- Disassembly precautions
- Tools required
- Prepare for disassembly
- Disassemble the radial end (ball bearing pumps)
- Disassemble the thrust end (ball bearing pumps)
- Disassemble the radial end (sleeve/ball bearing pumps)
- Disassemble the thrust end (sleeve/ball bearing pumps)
- Disassembly of the sleeve/Kingsbury bearing arrangement
- Disassemble the rotating assembly
- Preassembly inspections
- Reassembly
- Assemble the rotating element
- Install the rotating element
- Assemble the thrust end (ball bearing pumps)
- Assemble the radial end (ball bearing pumps)
- Assemble the thrust end (sleeve/ball bearing pumps)
- Assemble the radial end (sleeve/ball bearing pumps)
- Assemble the optional water jacket cover
- Assembly of the sleeve/Kingsbury bearing arrangement
- Post-assembly checks
- Assembly references
- Troubleshooting
- Parts Listings and Cross-Sectionals
- Other Relevant Documentation or Manuals
- Local ITT Contacts