Dynalab SMP30 - Manual (Page 8)

6
6. Use the Enter key to select “EXIT”. This will
cause the display to show the current action
of the SMP30; “COOLING TO AMBIENT”.
Once the SMP30 has returned to ambient
temperature, the screen will automatically
display the main menu.
7. Pressing the Enter key again to select “EXIT”
during the cooling program will return the
instrument to the main screen instantly.
Note:- Temperature values remain in the
memory until another melt cycle is initiated
with the “Start Ramp” instruction. The
instrument does not need to be connected
to an electrical supply to maintain the
storage of the recorded results.
5.7 Changing the Instrument Settings
Access to the instrument settings menu is only
available when initially switching on the SMP30.
The following instrument settings can be
changed by accessing this menu.
Plateau alarm ON/OFF
Head up display ON/OFF
Displayed language selection English,
Spanish,
French, Italian
or German
Time and date adjustment hh:mm and
dd:mm:yyyy
Preset program method settings Default
plateau
temperature
and ramp
rate
1. Ensure that the electrical supply to the
instrument is connected but the instruments
power switch is switched off.
2. Whilst switching the power on hold the
upper menu key, highlighted in the figure
below.
3. The SMP30 will display the following
screen:
Use the upper and lower menu keys next to
“YES” and “NO” to select whether to edit the
Alarm at Plateau setting. Selecting “YES” will
show a screen with options for that particular
setting and “NO” will move the screen on to
the next parameter.
If “YES” is pressed, the required upper and
lower menu keys should be selected to
determine that setting e.g. Alarm at Plateau
“ON” and “OFF”, using the upper or lower
menu key and then“DONE” should be selected
via the Enter key to move to the next
instrument setting.
For the language option the screen will show
“CHANGE TO SPANISH?”. Selecting the upper
menu key selects Spanish as the language and
the lower menu key moves the display on to
the next language. At any point selecting
“DONE” via the Enter key moves the screen on
to the next instrument setting.
Use the Enter key to select “EXIT” and return
to the instrument's main menu.
m e l t i n g p o i n t SMP30
ALARM AT PLATEAU : ON YES
CHANGE? NO
EXIT