Myron L 6Psi and 4P - Manual (Page 56)

52
9. The temperature value
measured by the 6Psi and
“°C” or “°F” will display (see
example in Figure 43).
Press .
10. The 6Psi generated LSI value
will display (see example in
Figure 44).
To store this LSI value in
memory, press .
If you do not wish to change
any of the variable values,
exit the LSI calculator by
pressing any parameter key
or by letting the unit time out.
B. LSI Calculator “User” Mode
LSI Calculator “User” mode allows you to change any or all of the variable
values then recalculate the saturation index using the adjusted value(s).
NOTE: You can only enter “User” mode AFTER 6Psi LSI value is displayed.
1. Press after the 6Psi
generated LSI value is
displayed.
2. “LSI AdJ” will display (see
Figure 45).
Press .
The 6Psi inferred value for
alkalinity and “AL” will display
(see example in Figure 46).
3. Press or to
adjust the displayed value to
the desired value.
Figure 43
°C
Figure 44
Figure 45
Figure 46