Pitco Frialator SSPE14 Electric Pasta EN - Manual (Page 10)

INSTALLATION
SSPE14: Floor Model Electric Pasta Cooker
7 L20-339, rev.02 (08/11)
 Check the low level sensor (4) to ensure that it moves freely up and down. This sensor will turn off the heat if
the water level goes below the heating element.
 Review the installation portion of this manual and ensure that all steps have been followed and executed
properly.
1.8. INITIAL CLEANING
When your appliance is shipped, many of its parts are covered with a thin coat of oil for protection. Before the
appliance is ready for cooking it must be cleaned. This will remove the oil coating and any foreign matter that may
have accumulated during storage and shipment. Refer to the following procedure to clean the appliance.
1. Read the operation section of this manual prior to filling or operating the appliance.
2. The following steps should be followed using a commercial cleaner.
3. Following the manufacturer’s directions, clean the tank interior and all other food contact surfaces.
4. When cleaning is complete, rinse the inside of the tank thoroughly with cool water. Continue to rinse the tank
until the cleaner has been completely and thoroughly rinsed from the tank.
5. Using a clean dry cloth, wipe out the inside of the tank to remove any residue from the cleaning process.
6. Repeat the previous steps to clean the rinse station if equipped.
LEGEND:
1- TEMPERATURE
PROBE
2- HIGH LIMIT SENSOR
3- MOUNTING WING NUT(S)
4- LOW LEVEL SENSOR
5- HEATING
ELEMENT
WARNING
Wear protective gloves and clothing when cleaning and draining the appliance and
when disposing of water. The water is extremely hot and can cause severe injuries.
WARNING
Use a commercial grade cleaner formulated to effectively clean and sanitize food
contact surfaces. Read the directions and precautionary statements before use.
Particular attention must be paid to the concentration of cleaner and the length of
time the cleaner remains on the food contact surfaces.
CAUTION
DO NOT leave the appliance
unattended during cleaning.
Never let the water level go
below the heating element.
CAUTION
Be careful not to disturb the
probe and high temperature
limit during operation and
cleaning of this appliance.