Pitco Frialator Gas Pasta Cookers PG14D - Manual (Page 25)

1-15
1.4.5 Initial Cleaning
WARNING
The power supply must be disconnected before servicing or cleaning
the appliance.
When the cooker is shipped, many of its parts are covered with a thin coat of shortening for protection.
Before the cooker is ready for use, it must be cleaned to remove the oil coating and any foreign matter
that may have accumulated during storage and shipment. Perform the cleaning as described below.
NOTICE
This is the first time the cooker will be turned on since leaving the
factory. Be watchful for any signs of trouble or unusual activity.
When a new piece of equipment is energized, unusual odors may be
apparent as new components heat up. This is normal. IF odors persist
or if excessive smoke is seen, turn the power to the cooker OFF at the
facility service panel. Have a qualified technician check out the
cooker for the cause.
a. Ensure that the drain valve is closed.
b. Fill the tank with water and add a packet of Pitco Fryer Cleaner to the water.
c. Turn the cooker on and allow it to reach normal operating temperature. Allow the unit to soak
at normal operating temperature (SIMMER) for fifteen (15) minutes to remove the coating.
d. Use the cleaning brush supplied with the cooker to clean the tank.
e. When the cleaning is complete, turn the cooker off.
f. Drain the water.
g. When the tank has cooled, rinse it thoroughly with cool water. Continue to rinse the tank until
all debris has been rinsed from the tank.
h. Now that the tank is clean, the cooker can be filled and operated.