Nor-Lake NL708 Door Alarm - Manual (Page 3)

Operating Instructions Alarm/Light Module XWA11V
01/14 Rev F. 142498 Page
2
3. INTERFACE
3.1 KEY FRONT PANEL OPERATION
In Programming Mode press to select a parameter or to confirm an operation.
Press and hold this key for more than 5 s to turn the controller OFF.
Press and hold this key for more than 1 s to turn the controller back ON.
Press to see the HIGH Temp ALARM (ALU parameter)
Press to see the LOW Temp ALARM (ALL parameter)
In Programming Mode press to browse parameter codes.
Press to increase the displayed value.
Press to mute the buzzer (+ relay) when an ALARM is happening.
Hot key programming: with the instrument on, insert the hot key and then press the UP
button.
In Programming Mode press to browse parameter codes.
Press to decreases the displayed value.
Switch ON and OFF the light of the cold room
KEY COMBINATIONS: PRESS SIMULTANEOUSLY
To lock and unlock the Keyboard.
To enter the Programming Mode.
To exit the Programming Mode.
To enter a new value for the HIGH Temp ALARM (ALU).
To enter a new value for the LOW Temp ALARM (ALL).
3.2 USE OF LEDS
Each LED function is described in the following table: