Alliance Laundry Systems SWD444C - Manual (Page 21)

Installation
19 802031 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Step 9: Connect the Washer and Dryer to
Electrical Power
Refer to sections on Electrical Requirements and
connect the washer and dryer to an electrical power
source that can support requirements found on serial
plate.
Figure 15
Figure 16
Step 10: Check Installation
Refer to Installer Checklist on the back cover and
make sure that unit is installed correctly.
Moving Unit to a New Location
To prevent damage while moving the unit, the
shipping materials MUST BE reinstalled.
Reinstallation of Shipping Materials
Disconnect unit from electrical supply.
Remove front access panel by removing two screws.
Place the shock sleeves on all four shock absorbers.
Refer to Figure 17.
Insert hooked end of shipping brace into the open slot
of the motor mount. Attach with bolts and lockwashers.
Refer to Figure 17.
Reinstall front access panel.
Figure 17
Refer to step 6 for proper procedures whenever the
unit is moved.
SWD730N
SWD731N
H336I
1 Shock Sleeves
2 Motor Mount
3 Bolts and Lockwashers
4 Hooked End of Shipping Brace
2
1
3
4