Asus P4P800 SE - Manual (Page 119)

ASUS P4P800 SE motherboard 5-17
This motherboard supports Intel ® RAID 0 and RAID 1 for Serial ATA drives
through the Intel ® ICH5R chipset. The Serial ATA as RAID option must be
enabled in the BIOS before the system can load the Intel ® RAID Option
ROM code for Intel ® RAID. The Intel ® RAID Option ROM is a standard
PnP (Plug and Play) option ROM that provides a pre-operating system
user interface for the Intel
® RAID implementation. It also allows the boot
order to be selected from within the BIOS setup utility.
To install the Serial ATA cable:
1. Attach either cable end to the SATA connector on the motherboard.
2. Attach the other cable end to the SATA hard disk.
3. Connect the SATA power cables.
1. Both the data and power SATA cables are new cables. You cannot
use the older 40-pin 80-conductor IDE or regular IDE power cables
with SATA hard drives.
2. Carefully follow any technical instructions that come from the hard
disk manufacturer.
5.6.1 BIOS Configuration
1. Turn ON the system and enter BIOS by pressing the Delete key
during the Power-On Self Test (POST).
2. From the BIOS screen, select the Main menu then the IDE
Configuration menu.
3. If necessary, switch the Onboard IDE Operate Mode option from
[Legacy Mode] to [Enhanced Mode].
4. Switch the Configure S-ATA as RAID option to [Yes].
5. Press to save the BIOS settings and exit the BIOS setup
program.
5.6.2 Installing Serial ATA (SATA) hard disks
Installing Serial ATA (SATA) hard disks requires the use of a new SATA
data cable (4-conductor) which supports the Serial ATA protocol and a
SATA power cable. Any end of the SATA data cable can be connected to
the SATA hard disk or the SATA connector on the motherboard.
For more information about the Intel ® RAID for SATA configuration,
refer to the Intel Application Accelerator, RAID Edition, User’s
manual in “\Manual\IAA RAID Manual.doc” of the support CD.
5.6 Intel ® RAID for Serial ATA configuration
(for Windows 2000 and Windows XP only)