Asus P4P800 SE - Manual (Page 99)

ASUS P4P800-E Deluxe motherboard 4-37
To set a User Password:
1. Select the Change User Password item and press .
2. On the password box that appears, type a password combination of at
least six (6) letters and/or numbers, then press .
3. Confirm the password when prompted.
The message “Password Installed” appears after you have
successfully set your password.
To change the user password, follow the same steps as in setting a user
password.
Clear User Password
Select this item if you wish to clear the user password.
Password Check [Setup]
When set to [Setup], BIOS checks for user password when accessing the
Setup utility. When set to [Always], BIOS checks for user password both
when accessing Setup and booting the system. Configuration options:
[Setup] [Always]
Boot Sector Virus Protection [Disabled]
Allows you to enable or disable the boot sector virus protection.
Configuration options: [Disabled] [Enabled]
4.7 Exit menu
The Exit menu items allow you to load the optimal or failsafe default values
for the BIOS items, and save or discard your changes to the BIOS items.
Pressing does not immediately exit this menu. Select one of the
options from this menu or from the legend bar to exit.
Exit Options
Exit & Save Changes
Exit & Discard Changes
Discard Changes
Load Setup Defaults
Exit system setup after
saving the changes.
F10 key can be used for
this operation.