AT&T 265 - Manual (Page 32)

30
CALLER ID OPERATION
Setting Options
Review Call Log
The screen displays call information
for about 10 seconds after it has
been received.
This function can be accessed
regardless of whether the handset
is lifted or not.
1. Press T or S to activate the call
list and display the latest caller ID
entry.
2. Press T once to show the
previous caller ID entry. Press T
repeatedly to scroll through the
call list in reverse chronological
order (from the latest entry to the
earliest entry), or
3. Press S twice when the screen is
in idle mode and it will show
-END OF LIST-. Then press S
repeatedly to scroll through the
call list in chronological order
(from the earliest entry to the
latest entry).
4. At the end of the call list, the
screen displays -END OF LIST-
and begins again.
Display Dial
Dial a displayed
telephone number
when reviewing
calls in call log.
1. Press S or T
until the screen
displays the
destination
number.
2. Press DISPLAY
DIAL to make the
call, LIFT
RECEIVER will be
displayed.
3. Lift the handset,
the number shall
be dialed out or
press the CLEAR
key to cancel this
operation.
NOTE:
The display dial
feature cannot be
used to dial PRIVATE
or UNKNOWN calls.
Call Log
A number (from 01 to 80) is
assigned numerically in ascending
order for each incoming call. The
most recent call will have the
highest number. Only the newest
entry from a telephone number will
be saved. When the memory is full,
the oldest call information is
replaced by the new incoming call
information.