AT&T 265 - Manual (Page 27)

25
Storing Numbers in Memory
1. Lift the handset.
2. Press and release PROG.
3. Dial the telephone number (up to
32 digits) or press PAUSE /REDIAL
to store the last number dialed
from this telephone.
4. For one-touch dialing, press and
release the memory button where
the number is to be stored (M1,
M2, or M3). For two-touch dialing,
press MEMORY, then press the
number button (0-9) where the
number is to be stored.
TELEPHONE MEMORY
This telephone can store 13 telephone numbers, each up to 32 digits. Dial the
numbers stored in memory by pressing one or two buttons.
Storing a CID Call Record into
Memory
1. Lift the handset.
2. Press S or T to display the call
record to be stored in memory.
3. Press PROG.
4. Go to step 4 above under Storing
Numbers in Memory.
NOTES:
If you pause for over 10 seconds
when programming an entry, the
procedure will time-out and you
will have to begin again.
If you have difficulty storing
numbers in memory, please see
Difficulty storing numbers in
memory on page 31.
Each 3.6 second pause counts as
one digit when storing numbers in
telephone memory.
Storing a Pause in
a Memory Number
Press and release
PAUSE/ REDIAL
once to store a 3.6
second pause in
the dialing
sequence, twice
for a 7.2 second
delay, three times
for a 10.8 second
delay.