Allied Telesis AR44xS series - Manual (Page 46)

Features in 276-02 46
Version 276-05
C613-10474-00 REV D
CR00012036 Firewall 3 Previously, the command set firewall policy=policy-name
othertimeout=minutes did not change the timeout period for firewall GRE
sessions.
This issue has been resolved.
Note that when a firewall session establishes, its timeout is initially set to
5 minutes. Once the session processes two or more packets, its timeout changes
to the value specified by this command.
Y Y Y Y Y - - - - Y
CR00012040 IP Gateway,
WAN load
balancer
3 If policy-based routing and the WAN load balancer were both configured, the
load balancer balanced traffic even if it matched the routing filter. Because the
purpose of policy-based routing is to control the route that traffic uses, this was
incorrect.
This issue has been resolved. Traffic that matches a policy-based routing filter
now bypasses the WAN load balancer.
Y Y Y - - - - - - -
CR00012175 OSPF 3 In a segmented NBMA network, in which more than one designated router was
elected for the network, sometimes the router or switch did not add the routes
to the extra designated routers. Note that a segmented network like this only
occurs as the result of an incorrect configuration.
This issue has been resolved. The router or switch correctly determines routes in
such a network.
Y Y Y Y Y Y Y Y Y Y
CR00012265 ATM 3 Previously, ATM interfaces stopped transmitting when any of the following
happened:
■ the command reset pri was entered
■ the command reset bri was entered
■ more than two ISDN calls were opened (on Software Versions prior to 2.7.6)
This issue has been resolved.
Y - - - - - - - - -
CR Module Level Description AR44x
S /
AR4
50S
AR7x5 AR750
S
Rapi
er
i
A
T-
880
0
A
T-
860
0
A
T-
870
0XL
A
T-
894
8
A
T-
990
0
A
T-
980
0