Atlantis Land A02-RA144-W300N - Manual (Page 32)

WebShare 144WN
A02-RA144-W300N Pag. 22
3.2.2 LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default
values are shown below.
Porta LAN Porta WAN
IP address 192.168.1.254 Mode= Routing
Encapsulation= PPPoA
Multiplex= VC
VPI= 8
VCI= 35
Subnet Mask 255.255.255.0
DHCP server function Enabled
IP addresses for
distribution to PCs 100 IP addresses
continuing from
192.168.1.100 through
192.168.1.199
3.3 Reset of WebShare Wireless N ADSL2+ Router
If you forget the password, you can restore router with Default Factory Setting
using “
Reset
” button in the rear of the product. To do this operation is necessary
be sure that led SYS is lit, then press “
Reset
” button for 10 seconds. The LED
SYS will turn off and it will blink; it will be lit when firmware with Factory Default
Setting will be loaded. Now you can enter on WebShare Wireless N ADSL2+
Router
with password “
atlantis
”.
3.4 Informations from the ISP
Before configuring this device, you have to check with your ISP (Internet Service
Provider) what kind of service is provided such as PPPoE, PPPoA, RFC1483, or
IPoA.
Gather the information as illustrated in the following table and keep it for
reference.
PPPoE
VPI/VCI, VC-based/LLC-based multiplexing, Username,
Password, Service Name, and Domain Name System (DNS)
IP address (it can be automatically assigned by your ISP when
you connect or be set manually).
PPPoA
VPI/VCI, VC-based/LLC-based multiplexing, Username,
Password, and Domain Name System (DNS) IP address (it
can be automatically assigned by your ISP when you connect
or be set manually).
RFC1483
Bridged VPI/VCI, VC-based/LLC-based multiplexing to use Bridged
Mode.
RFC1483
Routed
VPI/VCI, VC-based/LLC-based multiplexing, IP address,
Subnet mask, Gateway address, and Domain Name System
(DNS) IP address (it is fixed IP address).