Apple iMac (17-inch Mid 2006) - Manual (Page 32)

iMac (17-inch Mid 2006/Late 2006 CD) Take Apart — Front Bezel 32
Make sure the memory ejector levers are in the closed position (as shown) before lowering
the front bezel over the ejectors.
Continue to lower the font bezel down and press the top corners of the front bezel to
connect the latches. Note: Check that the latches are connected by lifting the front bezel at
each corner.
Replace the four bezel screws along the bottom of the computer.
Replace the access door and tighten the two captive screws.
Install any removed DIMMS after the unit is fully assembled. Important: Memory DIMMs
must be installed by hand. Do not use the memory ejector levers to install memory.
4.
5.
6.
7.
8.
922-7011, short
922-7749, long
Note: Shown in the order they
were removed.