Aquatic Infinity Series - Manual (Page 8)

AQUATIC INDUSTRIES, INC. 9
INSTALLATION INSTRUCTIONS
5. When placing the tub on a platform or cut out (see Diagrams), the opening should be 1” smaller than the
specified rim dimensions. Extreme care must be taken in this type of installation to ensure the tub will come
to rest entirely on the leveling feet.
6. IF YOU HAVE PURCHASED A WHIRLPOOL WITH AN INSTALLED TILE FLANGE, PROCEED TO
INSTRUCTION "2A".
LEVELING OF THE INFINITY I:
1. With a six foot level, level whirlpool left to right (see Diagram IF). Make sure that the level is placed on the
flat surface of the whirlpool, and not resting on the hump of the backrest or the tile flange.
2. Next, level the whirlpool front to back (see Diagram 1G). Put one end of the level on the center of the
recirculating discharge screen and the other end on the front lip of the whirlpool. Place a 3/8” spacer
between the level and the front lip of the whirlpool.
3. After leveling the front to back of the whirlpool, check the left to right level. If not level, re-adjust until
level. Check again until left to right and front to back are both level.
STRUCTURAL PREPARATION (continued):
1F
1G
Add 3/8” Spacer
Underneath Level