Aquatic Infinity Series - Manual (Page 7)

8 AQUATIC INDUSTRIES, INC.
INSTALLATION INSTRUCTIONS
Note: The bath should remain in its shipping carton until time of installation.
1. Literature dimensions are for reference only. Installation dimensions should be taken directly from the tub.
An access panel of 20" x 18" minimum must be provided at the pump end of the whirlpool allowing sufficient
clearance to make final connections and for servicing the pump and power panel. An additional access of
16'' x 16'' minimum must also be provided for the blower motor and control box.Access may be through
the wall or platform apron at the end of the unit. In the case of sunken installations, access should be made
through the ceiling below.
IT IS THE INSTALLER’S RESPONSIBILITY TO PROVIDE SUFFICIENT SERVICE ACCESS. MAKE ABSOLUTELY
CERTAIN THAT ACCESS PANELS AND/OR SERVICE OPENINGS ARE PROPERLY PLACED AND THAT ALL
POSSIBLE AREAS WHERE SERVICE MAY BE REQUIRED ARE ACCESSIBLE.
2. Install the drain fitting to the bath. Clearance may be needed for the drain by cutting away the subfloor (where
possible) or by blocking below the tub as may be required.
WARNING:
FACTORY SKIRTS DO NOT ALLOW FOR BLOCKING UP OF THE TUB BASE. All blocking must
be solid and provide uniform support to the tub base.
3. Tub must rest entirely on all leveling feet. DO NOT SUPPORT THE WEIGHT OF THE TUB BY THE RIM.
Lift unit and place into framework. If necessary, adjust feet until unit is completely touching on the leveled
sub floor. Secure the unit by fastening the bottom feet to the sub floor with any construction adhesive caulk.
For quieter operation and heat conservation, the walls surrounding the whirlpool may be insulated.
4. Frame out under the tub rim as shown in one of the illustrations below. NOTE: Due to the variety of
installations possible, framing procedures other than those described may be required. Plumb in selected
location using a level. Level front to back and across both sides. A ledge under the rim, or an apron without
a ledge, may be constructed as required (see Diagram 1A, 1B and 1C). Where installation will be against
a wall, stud wall framing should allow for wall sheathing material to run full length to the floor (see Diagram
1D
). Install tub firmly against sheathing as indicated, with blocking below rim to prevent deflection or
movement of tub. To prevent a rocking movement of tub after installation, it is important to have rim in
contact, but not supported by blocking material.
NOTE: Watertight installation of the drain and over flow is the installer’s responsibility. Drain and/or overflow
leakage is not included in the warranty of this product.
STRUCTURAL PREPARATION:
WARNING: ALL ELECTRICAL CONNECTIONS SHOULD BE MADE BY A LOCALLY LICENSED ELECTRICIAN.
1D Wall Installation 1E Sunken Installation
1B Ledge Installation - 2 1C Apron Installation
1A Ledge Installation - 1