Aquatic Infinity Series - Manual (Page 16)

AQUATIC INDUSTRIES, INC. 17
INFINITY AIR BATH CONTROL (SEE DIAGRAM 6C):
1. To Turn Air Bath System On: Pressing the On/Off
button will turn the blower on in “constant mode.” Once
the blower is on, pressing a second time will turn the
blower off. The light indicator will illuminate when the
system is on. The blower and the blower heater will
automatically shut off after a 20-minute period.
2. To Change Modes: Pressing the Mode button
alternates the blower modes of operation from constant
mode to wave mode and then to pulse mode.
•
Constant Mode: Consists of a constant blower level with no change. The light indicator will
also follow the blower intensity set by the user.
• Wave Mode: Consists of a gradual change of blower level to generate a gentle massage effect.
The light indicator will also follow the blower intensity.
• Pulse Mode: Consists of an instant change of the blower level to generate a massage effect.
The light indicator will also pulse as the blower does.
OPERATION of
INFINITY SERIES WHIRLPOOLS
INFINITY JET SEQUENCER CONTROL (SEE DIAGRAM 6B):
1. To Turn Jet Sequencer On: Pressing the “On/Off” button will turn the jet sequencer on. The system
will then perform an indicator light test and open all valves. Pressing the “On/Off” button a second
time will turn the jet sequencer off. A built-in timer automatically turns the jet sequencer off after
2 hours, unless manually deactivated first. Note: Pump must be turned on for the jet sequencer
to be effective (see “Infinity On/Off with Heater Control” above.)
2. To Choose Sequences: Press the “Sequences” button
to select one of the 7 preprogrammed massage
sequences. Note: Only the first 6 sequences have
corresponding indicator lights. The remaining sequences
do not have indicator lights. A preview of the massage
is displayed for 5 seconds after selecting a sequence.
3. To Change Speeds: Press the “Speeds” button to
change the time interval between each step of the
selected massage sequence.
Speed 1:
15 Seconds between each step.
Speed 2: 10 Seconds between each step.
Speed 3: 5 Seconds between each step.
4. To Pause: Press the “Pause” button to interrupt a massage sequence and prolong the action of a
jet set for a combination of sets. Pressing a second time will resume the massage sequence. The
“Pause” indicator light will be on in “Pause” mode.
Other Features:
• Automatic purge: Thirty minutes after the jet sequencer has shut off, the solenoids will open and close
to drain any water from the pipes.
BATHSIDE CONTROL SYSTEMS (continued):
6C
6B
●