Sony SVR-2000 - Manual (Page 85)

78
C h a p t e r 6 T r o u b l e s h o o t i n g
I can’t get the channel to change. (continued)
If you use cable with a set-top box:
• Make sure the set-top box is turned on.
• Make sure you are using the recorder’s remote control, and that you hold it so that the
TiVo button points toward the recorder, not a cable or satellite box.
• Refer to the Start Here booklet to verify that the IR Control cable is positioned
correctly.
• Press the TiVo button to go to TiVo Central, then select Messages & Setup, then
Cable/Satellite Box, then Control Cable Setup. Verify the IR code you chose during
Guided Setup. See page 7 for help choosing an IR code.
• If the installation instructions required you to connect a serial control cable, check that
the Serial Control cable is plugged into the upper serial jack on the back of the
recorder.
• Unplug the cable set-top box from the wall, then plug it back in.
If you use a satellite receiver with an IR Control cable:
• Make sure the satellite receiver is turned on.
• Refer to the Start Here booklet to verify that the IR Control cable is positioned
correctly.
• Press the TiVo button to go to TiVo Central, then select Messages & Setup, then
Cable/Satellite Box, then Control Cable Setup. Verify the IR code you chose during
Guided Setup. See page 7 for help choosing an IR code.
• Unplug the satellite set-top box from the wall, then plug it back in.