Sony SVR-2000 - Manual (Page 13)

6
C h a p t e r 1 G u i d e d S e t u p
* Use the UP/DOWN arrows until the picture of the recorder matches the
cable connection you used to connect your satellite receiver or cable box.
When the video status below the picture says “Video OK,” press SELECT to
continue. If the video status says “No Video,” double-check that the video
cable is firmly connected to the recorder and that you have selected the
correct type of video cable.
Satellite only
or cable with a box
only:
Satellite & antenna
or satellite & cable
without a box:
2. Follow the *directions at
the top of this page.
3. Use the DOWN arrow to
highlight “Accept these
input settings” and press
SELECT.
1. Use the UP/DOWN arrows to
highlight “Satellite Box” and
press SELECT.
Satellite & cable with a box:
1. Highlight “Satellite
Box” and press SELECT.
5. Highlight “Accept
these input settings”
and press SELECT.
3. Highlight “Cable
Box” and press
SELECT.
4. Follow the *directions
at the top of this page.
2. Follow the *directions
at the top of this page.