Notes on the wireless remote commander, Help guide – Sony HDR-PJ810 User Manual
Page 334
Digital HD Video Camera Recorder
HDR-PJ810/PJ810E/PJ820/PJ820E
Notes on the Wireless Remote Commander
Remove the insulation sheet before using the Wireless Remote Commander.
Point the Wireless Remote Commander towards the remote sensor to operate this product.
When no commands have been sent from the Wireless Remote Commander within a certain period, the light blue
frame disappears. When you press any of
/
/
/
, or ENTER again, the frame appears at the position where it
was last displayed.
You cannot select some buttons on the LCD monitor or on the viewfinder using
/
/
/
.
To change the battery of the Wireless Remote Commander
1. While pressing on the tab, inset your fingernail into the slit to pull out the battery case.
2. Place a new battery with the + side facing up.
3. Insert the battery case back into the Wireless Remote Commander until it clicks.
When the lithium battery becomes weak, the operating distance of the Wireless Remote Commander may shorten, or
the Wireless Remote Commander may not function properly. In this case, replace the battery with a Sony CR2025
lithium battery. Use of another battery may present a risk of fire or explosion.
4-489-505-11(1)
Copyright 2014 Sony Corporation
How to Use
334