ADTRAN AHDSL2 - Manual (Page 23)

61221002L2-5B B-7
ENT-CRS-T1 Command
Input Format
The choice to enter cross-connects may be accomplished either by selecting “12” from the Cross-Connection
Menu or by entering the command directly as shown in the example below where a cross-connect is initiated
between slot 1 and slot 21.
FROM[]= RT-1-1
TO[]= RT-1-21.
or
NOTE
A command that is typed directly can be entered from any level (menu or sub-menu).
Response Format
The user should receive a complied message such as the one below to indicate that the cross-connect was
successfully initiated.
Litespan2000 02-02-20 14:11:23
M 0 COMPLD
“RT-1-1,RT-1-21”
/* 1 T1 Cross-Connection Entered */
;
<
RTRV-CRS-T1 Command
Input Fomrat
Retrieving existing cross-connect status may be accomplished either by selecting “18” from the
Cross-Connection Menu or by entering the command directly as shown in the example below.
AID[ALL]= RT-1-1;
or
Response Format
If a cross-connect exists at the indicated slot, the user will see an indication of the slots involved in the cross-
connect as shown below.
Litespan2000 02-02-20 14:12:18
M 0 COMPLD
“RT-1-1,RT-1-21:::IS-NR,CRS”
/* 1 T1 Cross-Connection Retrieved */
;
<