Sony FDR-AX1 - Manual (Page 21)

Power Supply 21
P
repa
ra
ti
ons
You can charge the “InfoLITHIUM” battery pack
(L series) with the supplied Charger.
Notes
• You can use a large capacity battery pack, NP-F970
(supplied), with your camcorder. You cannot use NP-
F570/F770 (sold separately).
Notes
• You cannot use the AC-VL1 to connect the camcorder
to an outside power source. When you connect the
camcorder to a wall outlet (wall socket), use the
supplied AC Adaptor.
1
Set the mode switch to CHARGE.
2
Connect the power cord (mains lead) to
the Charger and the wall outlet (wall
socket).
3
Place the battery pack in the slot of the
Charger, press it down, and slide it in
the direction of the arrow.
The charge lamp turns on and charging starts.
After charging the battery
The charge lamp turns off (normal charge). If you
continue charging 1 more hour after the charge
lamp turns off, you can use the battery a little
longer (full charge).
Remove the battery pack from the Charger when
the charge is completed.
Attaching the battery pack
Press the battery pack against the back of your
camcorder and slide it down.
Removing the battery pack
Slide the POWER switch to OFF. Push the BATT
RELEASE (battery release) button and remove
the battery pack.
Notes
• Settings of the menu or settings adjusted using the
AUTO/MANUAL switch can be saved when the
POWER switch is set to OFF. Remove the battery pack
after the display on the LCD/viewfinder screen has
completely disappeared. Otherwise, changed settings
may not be saved.
• If you remove the battery pack or AC Adaptor with the
POWER switch ON, you cannot turn the camcorder on
even though you attach the battery pack or AC Adaptor
again.
Slide the POWER switch to OFF temporarily, then to
ON.
Preparations
Power Supply
Charging the battery pack
Power cord
(mains lead)
To the wall outlet
(wall socket)
Charge lamp
Mode switch
Charger AC-VL1
BATT RELEASE
(battery release) button