Sony PEG-N760C - Manual (Page 215)

215 Chapter6 Additional information
, IR HotSync operations do not work after you receive a low battery
warning. Check the battery power of your CLIÉ handheld. Recharge
the battery if necessary.
, If you have problems using a specific speed, select Prefs, Connection,
IR to a PC/Handheld, Edit, and then Details. Then select a lower
speed in the Details dialog box.
My CLIÉ handheld appears to freeze when I place it near my
computer.
, Move your CLIÉ handheld away from the computer’s infrared port.
, Make sure that you turn the Beam Receive function off.
My CLIÉ handheld displays the message “Waiting for sender”
when it is near my computer’s infrared port.
, Your computer’s infrared port may be set to search automatically for
the presence of other infrared devices. Do the following to turn off
this option:
1 In the Windows task bar, select Start, point to Settings, and then
select Control Panel.
2 Double-click Infrared.
3 Click the Options tab.
4 Clear the selection of the option “Search for and provide status for
devices within range.”
5 Click Apply and OK.
, Move your CLIÉ handheld away from the computer’s infrared port.
, Make sure that you turn the Beam Receive function off.
I cannot cancel a HotSync operation midway.
, You may not be able to cancel a job a few seconds after you start a
HotSync operation via a USB connection. Wait for a while and try
again.
Troubleshooting – Frequently Asked Questions
Continued on next page