Sony ICD-R100PC - Manual (Page 56)

56
Troubleshooting (continued)
3
Restart the computer.
The new setting will activate only if you restart the computer.
4
Start up the ICD-PCLINK Software, connect the cable to the IC
recorder and check to see if the communication between the
IC recorder and the computer is successful.
If a communication error occurs, repeat the above procedure from Step
1 , select a different mode setting in Step 2 and check the operation
again.
Notes
• In some cases the printer port mode setting may be changed when a different
application is installed in the computer. In such a case, set the printer port
mode again.
• If a printer or other devices had been connected to the printer port before
using the ICD-PCLINK Software, the printer port mode setting selected in
Step 2 may be automatically changed. In such a case, restart the computer. If
the communication is still unsuccessful, you need to change the setting.
We recommend you make a memo of the setting each time you change the
setting.