Sony ICD-R100PC - Manual (Page 14)

14
Starting Up the ICD-PCLINK Software (continued)
3
Connect the IC recorder to your computer.
Make sure that the IC recorder is in the stop mode and connect the
cable to the DIGITAL I/O connector of the IC recorder.
Note
Be sure not to connect the cable while operating the IC recorder (recording ,
playback, etc.). Doing so may damage the data in the IC recorder.
Notes
• If you leave the IC recorder connected to the computer for an extended period
of time, the batteries in the IC recorder may be exhausted. Be sure to
disconnect the cable from the IC recorder after use.
• Do not remove the batteries from the IC recorder while it is connected to the
computer.
• While the IC recorder is connected to the computer, you cannot operate the IC
recorder. The alarm playback, if set, will not be activated either.
4
Click [OK].
Data transmission between the IC recorder and the computer
starts.
When the data transmission is completed, the ICD-PCLINK main
window (Page 16) appears.
To DIGITAL I/O connector
Connecting cable (supplied)
Your computer
(For
connection
with the
computer,
see page 12.)