Allied Telesis AR700 Series - Manual (Page 9)

Features in 275-05 9
Version 275-05
C613-10473-00 REV D
CR00011510 IPsec 3 The maximum SPI value has been increased in the commands:
create ipsec saspecification=spec-id inspi=spi
outspi=spi [other parameters]
set ipsec saspecification=spec-id inspi=spi outspi=spi
[other parameters]
The spi is now an integer in the range 256 to 4294967295.
Y Y Y - - - - - - -
CR00011774 Switch 3 The dot1qTpFdbPort MIB entry displays the ports on which the switch has
learned MAC addresses. Previously, the switch started the list of ports at port 0
instead of port 1.
This issue has been resolved.
- - - - - - - Y Y -
CR00012014 Switch 3 Setting a port’s speed to a fixed speed (such as 100mfull) should also disable
automdi on the port. Previously, if the switch set the port speed to a fixed speed
during start-up before the switch had fully initialised, auto MDI was not disabled.
This issue has been resolved.
- - - - - - - Y Y -
CR00012175 OSPF 3 In a segmented NBMA network, in which more than one designated router was
elected for the network, sometimes the router or switch did not add the routes
to the extra designated routers. Note that a segmented network like this only
occurs as the result of an incorrect configuration.
This issue has been resolved. The router or switch correctly determines routes in
such a network.
Y Y Y - - - - Y Y -
CR00012283 Switch 3 Previously, it was not possible to create two protocol-based VLANs on the same
ports if they had the same protocol but a different Ethernet encapsulation.
This issue has been resolved, so you can now create such VLANs.
- - - - - - - Y Y -
CR Module Level Description AR400 AR7x5 AR750
S
Rapi
er
i
A
T-
880
0
A
T-
860
0
A
T-
870
0XL
A
T-
894
8
A
T-
990
0
A
T-
980
0