Allied Telesis AR700 Series - Manual (Page 40)

Features in 275-02 40
Version 275-05
C613-10473-00 REV D
CR00010847 Firewall 2 Previously, when two or more firewall policies were configured and NAT was
configured on a logical network interface, the firewall could cause a reboot when
handling TCP and ICMP packets.
This issue has been resolved.
Y Y Y Y Y - - - - Y
CR00010852 IPv4 2 When changing a parameter for a pre-defined local interface using the set ip
local command, although the change was completed, an inappropriate error
message was output.
Also, the command required an IP address to be specified, even if the IP address
of the interface was not being changed. If the same IP address was given, then
the command incorrectly failed with an error message.
These issues have been resolved.
Y Y Y Y Y Y Y Y Y Y
CR00010864 ETH 2 Previously, when Telneting to a bridging router’s IP address the bridge link failed.
This issue has been resolved.
Y Y Y - - - - - - -
CR00010896 Switch 2 AT-40/SC, AT-40/MT and AT-41/MT uplink modules would stay link down when
they were set to a fixed speed.
This issue has been resolved.
- - - Y - - Y - - -
CR00010897 ISAKMP 2 Previously, a reboot occurred if the last ISAKMP HASH payload had a length of
zero. This issue has been resolved by adding additional checks for processing
ISAKMP payloads. Y Y Y Y Y - - - - -
CR00010900 ISAKMP 2 Previously, a reboot could occur if an ISAKMP HASH payload was invalidly large.
This issue has been resolved by adding additional checks for processing ISAKMP
payloads.
Y Y Y Y Y - - - - -
CR00010901 ISAKMP 2 Previously, a reboot could occur if an ISAKMP ID payload was invalidly large.
This issue has been resolved by adding additional checks for processing ISAKMP
payloads.
Y Y Y Y Y - - - - -
CR Module Level Description A
R
400
A
R
7x5
A
R
750
S
Ra
p
ie
r
i
AT
-8
8
0
0
AT
-8
6
0
0
A
T
-87
00X
L
AT
-8
9
4
8
AT
-9
9
0
0
AT
-9
8
0
0