Allied Telesis AR700 Series - Manual (Page 32)

Features in 275-02 32
Version 275-05
C613-10473-00 REV D
CR00009331 IP Gateway 2 Previously, the command set ip route preference reset the OSPF neighbour
connection.
This issue has been resolved. The connection is no longer reset.
Y Y Y Y Y Y Y Y Y Y
CR00009361 IPv4 2 If the router or switch received a stream of IPv4-encapsulated IPv6 packets, a
memory leak could occur if no IPv6-over-IPv4 tunnel was configured.
This issue has been resolved.
Y Y Y Y Y - - Y Y Y
CR00009405 BGP 2 When BGP recorded a BGP peer route with a nexthop of 0 (a rare case), it entered
it into its next hop list table but then failed next time it checked the integrity of
the data on this list while reviewing the list after a link state change.
This issue has been resolved.
Y Y Y Y Y - - Y Y Y
CR00009409 Switch 2 In rare circumstances it was possible for the SFP LEDs to apparently freeze.
This issue has been resolved.
- - - - - - - Y Y -
CR00009421 QoS 2 When the command set qos was issued with parameters to set multiple flow
groups to the same action rule, the switch would reboot.
When the command set qos was issued with parameters to set multiple traffic
classes to the same action rule, the switch would reboot.
These issues have been resolved.
- - - - - - - Y Y -
CR00009425 Self Test 2 When the test module was used to test the Ethernet interfaces on the router, the
twisted pair loopback test would begin to fail on some ports after the test had
been run for a few minutes.
This issue has been resolved.
- - Y - - - - - - -
CR00009492 Switch 2 In the configuration file or output resulting from the commands create config
and show config dynamic, some VLAN commands were produced in an
incorrect order.
This issue has been resolved.
- - - Y Y Y Y Y Y -
CR Module Level Description A
R
400
A
R
7x5
A
R
750
S
Ra
p
ie
r
i
AT
-8
8
0
0
AT
-8
6
0
0
A
T
-87
00X
L
AT
-8
9
4
8
AT
-9
9
0
0
AT
-9
8
0
0