Allied Telesis AR700 Series - Manual (Page 37)

Features in 275-02 37
Version 275-05
C613-10473-00 REV D
CR00010318 RIP 2 If RIP was configured to send RIP version 2, then multiple routes to the same
destination with different masks were not correctly included in the RIP response
or trigger response messages. Only the best route was sent.
This issue has been resolved.
Y Y Y Y Y Y Y Y Y Y
CR00010365 DHCP 2 When creating a DHCP range, the help text invoked by the “?” offered the values
0 to 4294967295. However, the valid range of values is actually 0 to 256.
This issue has been resolved.
Y Y Y Y Y Y Y Y Y Y
CR00010367 IP Gateway
Switch
2 When an IP interface was added to a local interface the route was not being
added to hardware properly. This caused incorrect routing if a more general route
existed.
This issue has been resolved.
- - - - - - - - - Y
CR00010392 GRE 2 Previously, the router or switch could reboot if a ping packet was routed out via
a local IP interface.
Now, a local IP interface is no longer a valid value for the interface parameter of
the add ip route and add ip route template commands.
Y Y Y Y Y Y Y Y Y Y
CR00010521 BGP 2 When an IP route to a destination existed, and a better IP route to that destination
was inserted into the IP route table, BGP would only import the new route into
the BGP prefix list if it originated from the same protocol as the original IP route.
This issue has been resolved. BGP now imports the best IP route into the BGP
prefix list, even if it originated from a different routing protocol.
Y Y Y Y Y - - Y Y Y
CR00010539 Filter 2 When the router or switch sometimes forwarded packets unnecessarily slowly.
This happened if the forwarding interface was associated with an IP filter with a
variable field pattern, such as TCP session or ICMP code and type.
This issue has been resolved.
Y Y Y Y Y Y Y Y Y Y
CR Module Level Description A
R
400
A
R
7x5
A
R
750
S
Ra
p
ie
r
i
AT
-8
8
0
0
AT
-8
6
0
0
A
T
-87
00X
L
AT
-8
9
4
8
AT
-9
9
0
0
AT
-9
8
0
0