elektraLite Moving Yoke 120v Spot - Manual (Page 12)

- １１ - MY575 SPOT
- Main menu 2
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Press [UP] to select “SET”.
- Pan Reverse
With this function you can reverse the Pan-movement.
1.
Select “rPAN” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.
4. Press [ENTER] or [EXIT/DN] to exit.
- Tilt Reverse
With this function you can reverse the Tilt-movement.
1.
Select “rTIL” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.
4. Press [ENTER] or [EXIT/DN] to exit.
DEGR- Pan degree selection
With this function you can set the maximum pan to be either 540 or 630 degrees.
1.
Select “Degr” by pressing [UP] button.
2. Press [ENTER], the display shows “630” or “540”.
3. Press [UP] to change the selection.
4. Press [ENTER] to save and then [EXIT/DN] to exit.
- Switch 16 bit/8 bit
With this function you can switch MY575 from 16 bit to 8 bit resolution.
1.
Select “16BI” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” in order to set 16 bit, or “OFF” in order to set 8 bit. The channels PAN Fine
and TILT Fine will be disabled.
4. Press [ENTER] or [EXIT/DN] to exit.
- Reset
With this function you can Reset MY575 via the Display Panel.
1.
Select “rEST” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.
4. Press [ENTER] or [EXIT/DN] to exit.
- Restore factory settings
With this function you can restore the factory settings of MY575. All settings will be set back to the default
values (shaded). Any edited scenes will be lost.
1.
Select “LODA” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.