A.J. Antunes & Co TTD 815131004 - Manual (Page 3)

A. J. ANTUNES & CO. www.ajantunes.com 180 Kehoe Blvd., Carol Stream, Illinois 60188
1-630-784-1000 Fax: 630-784-1651 Page 3 of 4 P/N 1011093 06/10
1-800-253-2991
TTD Installation Information
Transformer Power Connections Warranty
1. Antunes Controls products are guaranteed to be free
from mechanical and electrical defects for a period of
one year from date of shipment under normal use and
service provided installation is made in accordance
with manufacturers’ recommendations.
2. Parts deemed defective shall be repaired or replaced
at manufacturers option and at manufacturers expense
but shall not include foreign or federal excise taxes,
state or municipal sale or use taxes, all such taxes
not limited to the foregoing being responsibility of the
purchaser.
3. No charge for travel and/or mileage will be allowed to
purchaser.
4. Antunes Controls reserves the right to make changes
in design or make any improvements on any products.
The right is always reserved to modify our equipment
because of new technology, underwriter’s requirements
and/or government regulations.
5. The following are not covered under warranty:
a. Failure from neglect, abuse, careless handling and
mis-application of unit.
b. Failure to observe guidelines for installation or
improper voltage hook-up.
c. Failure caused by improper maintenance.
d. Unless specifically allowed by Antunes Controls, no
other charges may be included under warranty.
Limitation of Liability: If it is understood and agreed
that seller’s liability whether in contract, in tort, under
any warranty, in negligence or otherwise, shall not
exceed the return of the amount of the purchase price
paid by purchaser and under no circumstances shall
seller be liable for special, indirect or consequential
damages. The price stated for the equipment is a
consideration in limiting seller’s liability. No action,
regardless of form, arising out of the transactions may
be brought by purchaser more than one year after the
cause of action has accrued.
Each transformer can power up to four display units.
If transformers other than those supplied by Antunes
Controls are used, the transformer colors/leads and
power capabilities may not be the same.
The unit will read “EEE” for over range conditions and
“---” for under range conditions.
If field calibration is required, a two point calibration with a
millivolt generator can be used. Calibrate the low reading
by adjusting the zero pot. Enter a second calibration
higher than the first and adjust the span. Recall these two
points if needed. Allow 30 minutes under power for unit to
stabilize before calibration.
NOTE: Transformer must be Class II to maintain UL
recognition.