Nikon D5100 - Manual (Page 54)

36
z
3
Choose a release mode.
Highlight a release mode and press J. To return
to shooting mode, press the shutter-release
button halfway.
A
The Memory Buffer
The camera is equipped with a memory buffer for temporary storage, allowing shooting to
continue while photographs are being saved to the memory card.
Up to 100 photographs
can be taken in succession; note, however, that frame rate will drop when the buffer is full.
While photographs are being recorded to the memory card, the access lamp next to the
memory card slot will light.
Depending on the number of the images in the buffer,
recording may take from a few seconds to a few minutes. Do not remove the memory card or
remove or disconnect the power source until the access lamp has gone out. If the camera is
switched off while data remain in the buffer, the power will not turn off until all images in the
buffer have been recorded.
If the battery is exhausted while images remain in the buffer, the
shutter release will be disabled and the images transferred to the memory card.
A
Buffer Size
The approximate number of images that can be stored in the
memory buffer at current settings is shown in the viewfinder
exposure-count display while the shutter-release button is pressed. The illustration shows
the display when space remains in the buffer for about 27 pictures.
A
Auto Image Rotation
The camera orientation recorded for the first shot applies to all images in the same burst,
even if the camera is rotated during shooting.
See “Auto Image Rotation” ( 0 172).
A
The Shooting Menu
The release mode can also be selected using the Release mode
option in the shooting menu (
0 151).
A
The Fn Button
The release mode can also be selected by pressing the Fn button and rotating the command
dial (
0 165).
A
See Also
For information on the number of photographs that can be taken in a single burst, see page
218.