Nikon N50 User Manual
While you're taking pictures, When you've taken a complete roll, Using the built-in flash
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WHILE YOU'RE TAKING PICTURES
Using the Built-In Flash
The flash can be used
when the subject is within
0.6 to 3m (2.0 to 9.8 feet)
when using a film with
ISO 100 and the AF
Zoom-Nikkor 35~80mm
fl4-fl5.6 D lens.
If a stationary
subject starts to
move
Remove your finger from
the shutter release
button and lightly press
again to restart
autofocus.
If i blinks inside the viewfinder, use the built-in flash. Press the flash
lock release button. Lightly press the shutter release button, wait for the
■ to come on in the viewfinder. Confirm the • (in-focus indicator)
appears in the viewfinder, then fully depress the shutter release button.
® If i blinks after shooting for a few seconds, this means that the light
might be insufficient. Check shooting distance, and if necessary,
move closer to subject and take a picture with flash again.
viewfinder Information
H t
blinks—Overexposure
possible
Use a film with lower ISO, or
use a Nikon Neutral Density
Filter.
L J —
0 “
—0 —
lo blìrìks—Underexposure
possible
Use the built-in flash.
[ ] blinks inside viewfinder—
Picture blur is possible
The light is probably dim and the
automatically selected shutter speed is
slow. This can cause picture blur due
to camera shake. Hold the camera
steady, or use a tripod. Or, use a built-
in flash.
“3^ i blinks (without flash)—
Flash
recommendation
This happens when it's dark.
Use the built-in flash.
• blinks—Unacceptable condition
for autofocus
Autofocus requires that the subject
have some contrast or details to focus
upon. Make sure the subject conforms.
You can't focus on the sky, a blank
wall, a very shiny surface, a subject
which has no details or contrast.
WHEN YOU'VE TAKEN A COMPLETE ROLL
Auto Rewind
When the film reaches the end of roll, it rewinds auto
matically. After rewinding is completed, remove the film.
® When battery power is very weak, or when temperature is
very low, film may not rewind at the end of roll;
Err
will appear
in the LCD panel. In this case, replace battery with a fresh
one, or wait for the temperature to rise and then press the
rewind button.
To rewind film at mid-roll: Press the
rewind button on the camera bottom.