Nikon D800 - Manual (Page 413)

En_03
389
n
Remote
terminal
accessories
• Remote Cord MC-22: Remote shutter release with blue, yellow,
and black terminals for connection to a remote shutter-
triggering device, allowing control via sound or electronic
signals (length 1 m/3 ft 3 in.).
• Remote Cord MC-30: Remote shutter release; can be used to
reduce camera shake (length 80 cm/2 ft 7 in.).
• Remote Cord MC-36: Remote shutter release; can be used for
interval timer photography or to reduce camera shake or
keep the shutter open during a time exposure (length
85 cm/2 ft 9 in.).
• Extension Cord MC-21: Can be connected to ML-3 or MC-series
20, 22, 23, 25, 30, or 36. Only one MC-21 can be used at a
time (length 3 m/9 ft 10 in.).
• Connecting Cord MC-23: Connects two cameras for
simultaneous operation (length 40 cm/1 ft 4 in.).
• Adapter Cord MC-25: Ten-pin to two-pin adapter cord for
connection to devices with two-pin terminals, including
the MW-2 radio control set, MT-2 intervalometer, and
ML-2 modulite control set (length 20 cm/8 in.).
• GPS Unit GP-1 ( 0 215): Record latitude, longitude, altitude,
and UTC time with pictures.
• GPS Adapter Cord MC-35 ( 0 215): This 35 cm (1 ft 2 in.) cable
connects the camera to older GARMIN eTrex- and geko-
series GPS units that conform to version 2.01 or 3.01 of the
National Marine Electronics Association NMEA0183 data
format. Only models that support PC interface cable
connections are supported; the MC-35 can not be used to
connect GPS units via USB. The units connect to the
MC-35 using a cable with a D-sub 9-pin connector
provided by the manufacturer of the GPS device; see the
MC-35 instruction manual for details. Before turning the
camera on, set the GPS device to NMEA mode
(4800 baud); for more information, see the
documentation provided with the GPS device.
• Modulite Remote Control Set ML-3: Allows infrared remote
control at ranges of up to 8 m (26 ft 3 in.).